- 您现在的位置：买卖IC网 > Sheet目录989 > MAX6655EVSYS (Maxim Integrated Products)EVAL KIT FOR MAX6655
Dual Remote/Local Temperature Sensors and
Four-Channel Voltage Monitors
Pin Description
PIN
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
NAME
V CC
DXP1
DXN1
ADD0
ADD1
DXP2
DXN2
GND
V IN3
V IN1
V IN2
ALERT
SMBDATA
OVERT
SMBCLK
STBY
FUNCTION
Supply Voltage. +5V for MAX6655; +3.3V for MAX6656. Bypass V CC to GND with a 0.1μF capacitor.
External Diode 1 Positive Connection. DXP1 is the combined current source and ADC positive input
for remote-diode 1. If a remote-sensing junction is not used, connect DXP1 to DXN1.
External Diode 1 Negative Connection. DXN1 is the combined current sink and ADC negative input
for remote-diode 1. DXN1 is normally biased to a diode voltage above ground.
SMBus Slave Address Select Input. ADD0 and ADD1 are sampled upon power-up. Table 5 is the
truth table.
SMBus Slave Address Select Input. ADD0 and ADD1 are sampled upon power-up.
External Diode 2 Positive Connection. DXP2 is the combined current source and ADC positive input
for remote-diode 2. If a remote-sensing junction is not used, connect DXP2 to DXN2.
External Diode 2 Negative Connection. DXN2 is the combined current sink and ADC negative input
for remote-diode 2. DXN2 is normally biased to a diode voltage above ground.
Ground
External Voltage Monitor 3. V IN3 is typically used to monitor +2.5V supplies.
External Voltage Monitor 1. V IN1 is typically used to monitor +12V supplies.
External Voltage Monitor 2. V IN2 is typically used to monitor voltage supplies of +3.3V for MAX6655
and +5.0V for MAX6656.
SMBus Alert (Interrupt) Output, Open-Drain
SMBus Serial-Data Input/Output, Open-Drain
Overtemperature Alarm Output, Open-Drain. OVERT is an unlatched alarm output that responds to
the programmed maximum temperature limit for all temperature channels.
SMBus Serial-Clock Input
Hardware Standby Input. Drive STBY low for low-power standby mode. Drive STBY high for normal
operating mode. Temperature and comparison threshold data are retained in standby mode.
Detailed Description
The MAX6655/MAX6656 are voltage and temperature
monitors that communicate through an SMBus-compat-
ible interface with a microprocessor or microcontroller
in thermal management applications.
Essentially an 11-bit serial ADC with a sophisticated front
end, the MAX6655/MAX6656 contain a switched-current
source, a multiplexer, an ADC, an SMBus interface, and
the associated control logic. Temperature data from the
ADC is loaded into a data register, where it is automati-
cally compared with data previously stored in over/under-
temperature alarm threshold registers. Temperature data
can be read at any time with 11 bits of resolution.
The MAX6655/MAX6656 can monitor external supply volt-
ages of typically 12V, 2.5V, and 3.3V for the MAX6655
and 5.0V for the MAX6656, as well as their own supply
voltage. All voltage inputs are converted to an 8-bit code
using an ADC. Each input voltage is scaled down by an
on-chip resistive-divider so that its output, at the nominal
input voltage, is approximately 3/4 of the ADC’s full-scale
range, or a decimal count of 198.
ADC
The averaging ADC integrates over a 40ms period (typ)
with excellent noise rejection. The ADC converts a tem-
perature measurement in 125ms (typ) and a voltage
measurement in 62.5ms (typ). For temperature mea-
surements, the multiplexer automatically steers bias
currents through the remote diode, then the forward
voltage is measured and the temperature is computed.
The DXN input is biased at one diode drop above
ground by an internal diode to set up the ADC inputs for
a differential measurement. The worst-case DXP-DXN
differential input voltage range is +0.25V to +0.95V.
Excess resistance in series with the remote diode caus-
es about +1/2°C error/ ? . A 200μV offset voltage at
DXP-DXN causes about -1°C error.
_______________________________________________________________________________________
5
发布紧急采购，3分钟左右您将得到回复。
相关PDF资料
MAX6660EVKIT
EVAL KIT FOR MAX6660
MAX6662EVKIT+
EVALUATION KIT FOR MAX6662
MAX6683EVKIT
EVAL KIT FOR MAX6683
MAX6969EVKIT+
KIT EVAL FOR MAX6969
MAX7500EVKIT+
KIT EVAL FOR MAX7500
MAX8630XEVKIT+
KIT EVAL FOR MAX8630X MAX8630W
MAX8678EVKIT+
KIT EVAL FOR MAX8678
MAX9635EVKIT+
KIT EVAL FOR MAX9635
相关代理商/技术参数
MAX6655MEE
功能描述:板上安装温度传感器 RoHS:否 制造商:Omron Electronics 输出类型:Digital 配置: 准确性:+/- 1.5 C, +/- 3 C 温度阈值: 数字输出 - 总线接口:2-Wire, I2C, SMBus 电源电压-最大:5.5 V 电源电压-最小:4.5 V 最大工作温度:+ 50 C 最小工作温度:0 C 关闭: 安装风格: 封装 / 箱体: 设备功能:Temperature and Humidity Sensor
MAX6655MEE+
功能描述:板上安装温度传感器 Dual Remote/Local Temperature Sensor RoHS:否 制造商:Omron Electronics 输出类型:Digital 配置: 准确性:+/- 1.5 C, +/- 3 C 温度阈值: 数字输出 - 总线接口:2-Wire, I2C, SMBus 电源电压-最大:5.5 V 电源电压-最小:4.5 V 最大工作温度:+ 50 C 最小工作温度:0 C 关闭: 安装风格: 封装 / 箱体: 设备功能:Temperature and Humidity Sensor
MAX6655MEE+T
功能描述:板上安装温度传感器 Dual Remote/Local Temperature Sensor RoHS:否 制造商:Omron Electronics 输出类型:Digital 配置: 准确性:+/- 1.5 C, +/- 3 C 温度阈值: 数字输出 - 总线接口:2-Wire, I2C, SMBus 电源电压-最大:5.5 V 电源电压-最小:4.5 V 最大工作温度:+ 50 C 最小工作温度:0 C 关闭: 安装风格: 封装 / 箱体: 设备功能:Temperature and Humidity Sensor
MAX6655MEE-T
功能描述:板上安装温度传感器 RoHS:否 制造商:Omron Electronics 输出类型:Digital 配置: 准确性:+/- 1.5 C, +/- 3 C 温度阈值: 数字输出 - 总线接口:2-Wire, I2C, SMBus 电源电压-最大:5.5 V 电源电压-最小:4.5 V 最大工作温度:+ 50 C 最小工作温度:0 C 关闭: 安装风格: 封装 / 箱体: 设备功能:Temperature and Humidity Sensor
MAX6656MEE
功能描述:板上安装温度传感器 Dual Remote/Local Temperature Sensor RoHS:否 制造商:Omron Electronics 输出类型:Digital 配置: 准确性:+/- 1.5 C, +/- 3 C 温度阈值: 数字输出 - 总线接口:2-Wire, I2C, SMBus 电源电压-最大:5.5 V 电源电压-最小:4.5 V 最大工作温度:+ 50 C 最小工作温度:0 C 关闭: 安装风格: 封装 / 箱体: 设备功能:Temperature and Humidity Sensor
MAX6656MEE+
功能描述:板上安装温度传感器 Dual Remote/Local Temperature Sensor RoHS:否 制造商:Omron Electronics 输出类型:Digital 配置: 准确性:+/- 1.5 C, +/- 3 C 温度阈值: 数字输出 - 总线接口:2-Wire, I2C, SMBus 电源电压-最大:5.5 V 电源电压-最小:4.5 V 最大工作温度:+ 50 C 最小工作温度:0 C 关闭: 安装风格: 封装 / 箱体: 设备功能:Temperature and Humidity Sensor
MAX6656MEE+T
功能描述:板上安装温度传感器 Dual Remote/Local Temperature Sensor RoHS:否 制造商:Omron Electronics 输出类型:Digital 配置: 准确性:+/- 1.5 C, +/- 3 C 温度阈值: 数字输出 - 总线接口:2-Wire, I2C, SMBus 电源电压-最大:5.5 V 电源电压-最小:4.5 V 最大工作温度:+ 50 C 最小工作温度:0 C 关闭: 安装风格: 封装 / 箱体: 设备功能:Temperature and Humidity Sensor
MAX6656MEE-G05
功能描述:板上安装温度传感器 RoHS:否 制造商:Omron Electronics 输出类型:Digital 配置: 准确性:+/- 1.5 C, +/- 3 C 温度阈值: 数字输出 - 总线接口:2-Wire, I2C, SMBus 电源电压-最大:5.5 V 电源电压-最小:4.5 V 最大工作温度:+ 50 C 最小工作温度:0 C 关闭: 安装风格: 封装 / 箱体: 设备功能:Temperature and Humidity Sensor